Empire Comfort Systems CHR User Manual
CHG/CHR
Page 11
1.
Fireplace won't light when the piezo ignitor is depressed.
a.
a.
With the gas tuned off depress the piezo ignitor to check the
spark. You should see a spark jump from tip of the electrode.
If there is a spark, check the gas supply. Is the tank full? Is
the line purged of air? Can you light the burner with a
match?
spark. You should see a spark jump from tip of the electrode.
If there is a spark, check the gas supply. Is the tank full? Is
the line purged of air? Can you light the burner with a
match?
b.
Check air shutter adjustment, close as needed.
c.
Check the orifice for blockage.
d.
Is the electrode tip clean and free from debris?
e.
Clean electrode tip.
2.
Burner flame is yellow or orange and there is a smell of gas.
a.
a.
Check the burner inlet for obstructions.
b.
Check the air shutter for proper adjustment.
c.
Check for spiders, spider webs and debris.
3.
Low heat with control knob set on "HI."
a.
a.
Is the fuel hose bent or kinked?
TROUBLE-SHOOTING
If your outdoor gas fireplace does not function properly, use the following checklist for possible solutions.
b.
Is there an adequate gas supply?
c.
Does the orifice or burner need cleaning?
d.
Is the air shutter too far open or closed?
e.
Is the gas supply, or gas pressure low?
4.
The smell of gas with flames appearing sooty yellow.
a.
a.
Check for spiders or insects.
b.
Spiders and insects can nest in the burner and cause a
disruption in the flow of gas from the burner. This is
dangerous and can cause a fire behind the valve cover,
damaging the outdoor gas fireplace and making it unsafe to
operate.
You should inspect the burner immediately if any of these
conditions occur or persist.
disruption in the flow of gas from the burner. This is
dangerous and can cause a fire behind the valve cover,
damaging the outdoor gas fireplace and making it unsafe to
operate.
You should inspect the burner immediately if any of these
conditions occur or persist.
5.
The burner makes popping noises.
a.
a.
Check air shutter adjustment.
b.
Check burner for clogged ports.
PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide.
Index
Part
No.
Number
Description
Index
Part
No.
Number
Description
1
R-5647
BOTTOM LOG
2
R-5649
RIGHT CROSS LOG
3
R-5648
LEFT CROSS LOG
4
R-5634
RAIN CAP WITH KNOB AND
HANGER CLIP - RED
HANGER CLIP - RED
4
R-5659
RAIN CAP WITH KNOB AND
HANGER CLIP - GREEN
HANGER CLIP - GREEN
5
R-5631
CHIMENEA STACK CASTING -
RED
RED
5
R-5657
CHIMENEA STACK CASTING -
GREEN
GREEN
6
R-5630
CHIMENEA BODY CASTING -
RED
RED
6
R-5656
CHIMENEA BODY CASTING -
GREEN
GREEN
7
R-5651
DOOR SCREEN
8
R-5633
LEG WITH RUBBER FEET - RED
(3 REQ’D)
(3 REQ’D)
8
R-5658
LEG WITH RUBBER FEET -
GREEN (3 REQ’D)
GREEN (3 REQ’D)
9
R-5636
BURNER ASSEMBLY
9.1
R-5909
CAST BURNER ASSEMBLY
WITH PIPE AND VENTURI
WITH PIPE AND VENTURI
9.2
R-5638
VALVE COVER
9.3
R-5639
ORIFICE - LPG
9.4
R-5640
ORIFICE - NAT
9.5
R-5641
SAFETY VALVE
9.6
R-5642
THERMOCOUPLE
9.7
R-3992
REGULATOR HOSE ASSEMBLY
- LPG (26")
- LPG (26")
9.8
R-2708
PIEZO IGNITOR
9.9
R-5908
ELECTRODE AND WIRE
ASSEMBLY
ASSEMBLY
9.10
R-5644
LABEL SET ON CHAIN
(ATTACHED TO VALVE COVER)
(ATTACHED TO VALVE COVER)
9.11
R-3357
VALVE SPRING
9.12
R-3358
AIR SHUTTER
9.13
R-5645
VALVE KNOB
10
R-5653
TANK SECURING HOOK WITH
BOLT, WASHER AND NUT
BOLT, WASHER AND NUT
NOT SHOWN R-5635
STACK RESTRICTOR PLATE
NOT SHOWN R-5646
BURNER MOUNTING BAR
NOT SHOWN R-5650
FLICKER SHIELD (2 REQUIRED)
NOT SHOWN R-5913
IGNITOR BRACKET