Mitsubishi Electronics FX3G User Manual
63
FX
3S
/FX
3G
/FX
3GC
/FX
3U
/FX
3UC
Series
Programming Manual - Basic & Applied Instruction Edition
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
1
Introdu
ction
2
Ov
ervi
ew
ew
3
Instruction
Li
st
4
D
evices
in Det
ai
l
5
Specifi
ed the
De
vice
&
C
onst
ant
ant
6
Bef
ore
ore
Pr
og
ra
mmi
ng
ng
7
Bas
ic
ic
Instruction
8
FN
C00-FN
C00-FN
C0
9
Program Fl
ow
9
FNC
10-FN
C19
Mov
e & Com
e & Com
pare
10
FNC
20-FNC
29
Arith. & Lo
gi
c
Operati
on
6
Set the Built-in CC-Link/LT
1. Set the built-in CC-Link/LT on the Built-in CC-Link/LT Setting dialog box.
*1.
Select 16-point mode when using remote device stations. Remote device stations cannot be set in 4-point
mode.
Only station numbers 40 to 64 are available for remote device stations.
mode.
Only station numbers 40 to 64 are available for remote device stations.
*2.
The station numbers 32, 48 and 64 are available when a remote device station is selected in Station type.
2. Click the [OK] button to finish the setup and close the Built-in CC-Link/LT setup dialog box.
Set item
Contents of setting
Setting range
Transmission Speed
Select one of the following supported built-in CC-Link/LT transmission rates:
2.5Mbps
625kbps
156kbps
2.5Mbps
625kbps
156kbps
–
Point Mode
Select one of the following supported point modes:
16-point mode
4-point mode
16-point mode
4-point mode
–
Station No.
This item indicates the station number of the built-in CC-Link/LT module.
Station numbers 1 to 64 are available.
Station numbers 1 to 64 are available.
–
Station Type
Select one of the following station type:
Remote I/O station (Input)
Remote I/O station (Output)
Remote I/O station (Input/Output)
Remote device station
Remote I/O station (Input)
Remote I/O station (Output)
Remote I/O station (Input/Output)
Remote device station
*1
–
I/O Points
Select one of the following supported I/O point counts for each remote
I/O and remote device station: 1 to 16, 32, 48, 64
I/O and remote device station: 1 to 16, 32, 48, 64
*2
1 to 16, 32, 48, 64
*2
Specify Reserved Station
Select whether or not the Built-in CC-Link/LT station is specified as a reserved
station.
station.
–
Up
This button moves the cursor to the upper line (transposes the upper line).
–
Down
This button moves the cursor to the lower line (transposes the lower line).
–
Insert Row
This button inserts a line in the currently selected position.
–
Delete Row
This button deletes the currently selected line.
–
Read Buffer Memory
Click this button to read the transmission rate, point mode and station
information of the built-in CC-Link/LT module.
information of the built-in CC-Link/LT module.
–