Chariot Carriers CX 2 User Manual

Pressing down the locking button on the axle, insert the XC 
Skiing Kit into the axle socket on the Chariot CX until it can go 
no further. Release the locking button. The axle will now click if 
installed fully.
Make sure the skis are inserted correctly with the ski tips 
towards the front of the carrier.

DANGER

Always check that both ski frames are properly attached 
by pulling the ski frame outwards hard without pressing the 
axle’s locking button. To do this, lift the carrier slightly and 
hold it fi rm with one hand. Make sure that the ski cannot be 
pulled off, by giving it a few good shakes.

Insert each arm into the VersaWing 2.0 until the vertical holes 
in the arms and VersaWing 2.0 are aligned with each other. The 
arms should now, at the back in the slot of the VersaWing 2.0, 
protrude about 2 cm / 3/4“ over the plastic edge.

DANGER

Always make sure that the security pins of the ski arms are 
properly inserted  to prevent the carrier from accidentally 
sliding away. You run the risk of an accident!

TIP

The holes in the ski arms are larger than the security pins, 
so that the arms can rotate slightly around their longitudinal 
axes (in order to adapt to narrow or wide hips, and single and 
double width carriers).

Now secure the arms by inserting the security pin from above 
through the vertical hole in the arm and VersaWing 2.0 until it 
stops. Lock the security pin by looping the spring clip over the 
pins end that protrudes underneath the VersaWing 2.0.