A&D HV-G Series User Manual

Page of 69
HV-G Instruction Manual Page 13
Example:-. Display of the counting mode.
This mode uses the registered unit mass, counts the
amount of articles on the pan. The unit is PCS.
Example:- Storing the unit mass in the counting mode.
This is a display of zero point for counting mode and uses
20 pieces for the unit mass registration.
Example:- Storing the unit mass in the counting mode.
Sign “-” means “weighing value is not zero”.
Sample number is 10 pieces.
Example:- Percentage mode.
This mode uses the registered 100% mass, converts the
weighing value to a percentage. The unit is %
 .
Example:- Display of the function table.
This function table sets parameters of items.
<
 switch
Selecting an item.
^
 switch
Selecting a parameter of the item.
  
ENTER
  switch Storing new parameters.
Example:-. Preset tare. Entering tare with digital input.
<
 switch
Selecting a figure.
^
 switch
Selecting a number.
  
ENTER
  switch Storing new tare.
Example:- Hold display
The hold display is set using 
f12
 of the function table.
When weighing value is “near-zero” or changes more than
25% +30 digits, the hold is cancelled.
Overload display.
Remove everything from the pan.
Weighing error.
Check the base unit and weighing pan.
Calibration error.
Means “Calibration mass is too light”.
Check the base unit and weighing pan.