Preh MC25-35\ User Manual

 

14 

 

Figure 12 

 

4.  Repeat the same process as in point 3 for “Terminator”. 

  

5.  Click OK, and then go to File>UpdateKeyboard. Wait until programming is 

completed. 

 

1.  Connect your keyboard and start DOS programmer. 

 

2.  Go to the File menu and select “Read keytable”. This command will read all 

data and settings that are inside the keyboard. Please, make sure that the 
keyboard is connected. A status bar will show you when the reading of the 

keyboard has been completed as shown in figure 13 

 

Figure 13