A&D GP-60K User Manual

 

 73

This is a programmable unit conversion function. It multiplies the weighing data in kilograms by an 
arbitrary coefficient set in the function table and displays the result.   

The coefficient must be within the range between the minimum and maximum shown below. If the 
coefficient set is beyond the range, an error is displayed and the balance returns to the coefficient 
setting mode, prompting to enter an appropriate value. A coefficient of 1 was set at the factory. 

Model 

Minimum coefficient Maximum coefficient 

GP-12K/20K/30K/30KS/40K/61K/61KS

10000 

GP-60K/60KS/100K/100KS 1000 
GP-32K/32KS 1000 
GP-102K 

 

0.000001 

100 

 

 

1  Press and hold the SAMPLE key until ba5fnc of the function table is displayed, then release the 

key. 

2  Press the SAMPLE key several times to display    mlt

Cadj

 . 

3  Press the PRINT key. The balance enters the mode to confirm or set the coefficient. 

4  The current coefficient is displayed with the first digit blinking.   

  

When it is not to be changed, press the CAL key and proceed to step 6. 

  

When it is to be changed, press the RE-ZERO key 

and proceed to step 5. 

5  Set the coefficient using the following keys. 

SAMPLE key 

To select a digit to change the 

value. The selected digit blinks. 

RE-ZERO key 

To change the value. 

MODE key 

To change the decimal point 

position. 

 

Each time the switch is pressed, 

the decimal point position 
changes as follows: 

 

 

 

PRINT key 

To store the new setting, display end and go to step 6. 

CAL key 

To cancel the new setting and go to step 6. 

6  The balance displays    Unit . Press the CAL key to exit the programmable-unit function and 

return to the weighing mode. 

Press the MODE key to select the programmable-unit (no display on the unit section). Perform 

weighing as described in “5-1 Basic Operation (Kilogram Mode)”. After weighing, the balance 
displays the result (weighing data in kilograms x coefficient).