Toshiba Z300 User Manual
System Configuration Setup
Configuring MegaRAID IDE
167
Use the arrow navigation keys and press the Spacebar to select or
deselect the drive or drives to be part of the array. Press <Enter>
when done. If you select mirror mode as the array type, you must
select two drives to be in the array. This pop-up window will
appear only when configuring RAID 0 (Stripe) and RAID 1 (Mir-
ror) arrays.
deselect the drive or drives to be part of the array. Press <Enter>
when done. If you select mirror mode as the array type, you must
select two drives to be in the array. This pop-up window will
appear only when configuring RAID 0 (Stripe) and RAID 1 (Mir-
ror) arrays.
Stripe Size
Stripe size field applies to stripe mode arrays only. By default, an
array is set up with 64 KB stripes. Edit this field to change the
default stripe size. The options for the size of the Stripes are listed
in the table below.
array is set up with 64 KB stripes. Edit this field to change the
default stripe size. The options for the size of the Stripes are listed
in the table below.
NOTE: You cannot change the stripe size of an array that has
already been configured.
already been configured.
DRIVE SELECTION BOX
[
] Cntlr 0-Primary Master
[
] Cntlr 0-Secondary Master
STRIPE
32 KB
64 KB
64 KB
128 KB
256 KB
512 KB
256 KB
512 KB
1024 KB
2048 KB
4096 KB
2048 KB
4096 KB