Avanti CF1016 User Manual

Page of 20
 
  ELECTRICAL CONNECTION 
 
 
 
 
 
This appliance should be properly grounded for your safety.  The power cord of this  appliance is 
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the 
possibility of electrical shock. 
 
Do not under any circumstances cut or remove the third ground prong from the power cord supplied. For 
personal safety, this appliance must be properly grounded. 
 
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three-prong. 
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly 
grounded. When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to 
have it replaced with a properly grounded 3-prong wall outlet.  
 
The cord should be secured behind the appliance and not left exposed or dangling to prevent 
accidental injury. 
 
The appliance should always be plugged into its own individual electrical  outlet which has a voltage 
rating that matches the rating label on the appliance. This provides the best performance and also 
prevent overloading house wiring circuits that could cause a fire hazard from overheated. Never unplug 
the appliance by pulling the power cord.  Always grip the plug firmly and pull straight out from the 
receptacle.  Repair or replace immediately all power cords that have become frayed or otherwise 
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. 
When moving the appliance, be careful not to damage the power cord. 
 
 
 
EXTENSION CORD 
 Because of potential safety hazards under certain conditions, it is strongly recommended that you do 
not use an extension cord with this appliance. However, if you must use an extension cord it is 
absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord 
having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at least 
10 amperes. 
 
 
SURGE PROTECTOR 
Most electrical appliances use a series of electric control boards to operate.  These boards are very 
susceptible to power surges and could be damaged or destroyed.   
 
If the appliance is going to be used in an area or if your city / country is prone to power surges / outages; 
it is suggested that you use a power surge protector for all electrical devices / appliances you use.  The 
surge protector that you select must have a surge block high enough to protect the appliance it is 
connected to.  If you have any questions regarding the type and size of surge protector needed contact 
a licensed electrician in your area. 
 
Damages due to power surges are not considered a manufacturer covered defect and will void your 
product warranty. 
 
 
Warning
 
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is 
damaged, have it replaced by an authorized Avanti Products service center.