Smeg DO10PSS-5 User Manual
Instructions for the user
48
13.6 Removing door (large oven)
Hold the door on both sides with both hands near hinges A and raise levers B. Lift up the door forming
an angle of about 45° and remove. To refit, slide the hinges A in the grooves, drop the door and
release levers B.
an angle of about 45° and remove. To refit, slide the hinges A in the grooves, drop the door and
release levers B.
13.7 Removing door (small oven)
Open the door completely and fit pins (supplied) into the holes from the inside. Close the door to an
angle of about 45°, lift it and remove it from its seat. To replace, fit the hinge into the groove provided,
then lower the door until it comes to rest and extract the pins. If the pins are lost, two screwdrivers can
also be used.
angle of about 45°, lift it and remove it from its seat. To replace, fit the hinge into the groove provided,
then lower the door until it comes to rest and extract the pins. If the pins are lost, two screwdrivers can
also be used.
13.8 Oven door seal
To permit thorough cleaning of the oven, the seal may be removed. Before
removing the seal, take off the door as described above. Once the door has been
taken off, lift the tabs at the corners as shown in the figure.
After cleaning, refit the seal with the longer side horizontal and insert the tabs into
the appropriate holes starting from the top ones.
removing the seal, take off the door as described above. Once the door has been
taken off, lift the tabs at the corners as shown in the figure.
After cleaning, refit the seal with the longer side horizontal and insert the tabs into
the appropriate holes starting from the top ones.