Philips InfraCare infrared lamp HP3631 HP3631/01 User Manual
Product codes
HP3631/01
Note: The heat of the appliance does not reach its full intensity until several minutes after you switch
on the appliance. This does not mean, however, that the appliance is not effective during these first
minutes.
Duration of treatment
The duration of the treatment depends on the type of treatment and the person to be treated.
Treatment of a single muscle or joint should last approximately 15 minutes. If necessary, the
treatment can be repeated several times a day. A longer treatment time than 15 minutes does not
lead to better results. You can repeat the course of several treatments a day on several consecutive
days to get a result. If there is no improvement after 6-8 treatments, stop using the appliance and
consult your doctor. For chronic problems, the appliance can be used for longer periods of time, as
long as you follow the instructions given in the ‘Warning’ section in chapter ‘Important’.
using the infracare
1
Put the mains plug in the wall socket.
2
Press the on/off button to switch on the appliance (Fig. 12).
, The green power-on light goes on.
3
Press the timer button to set the desired treatment time (0-99 minutes). Keep the button
pressed to adjust the time more quickly.
, The set time is shown on the display.
, Two seconds after you release the timer button, the timer starts to count down in minutes.
The last minute is displayed in seconds. During countdown, the remaining time flashes on the
display.
Note: To change the set time during treatment, keep the timer button pressed for 2 seconds until ‘00’
appears on the display. Then use the timer button to set a new treatment time.
, When the set time has elapsed, you hear an intermittent beep and ‘00’ flashes on the display.
4
Press the timer button to stop the beeping. If you do not press the timer button, the beeping
automatically stops after 45 seconds.
Note: The timer does not switch off the appliance. It only signals that the set time has elapsed.
5
After use, press the on/off button to switch off the appliance.
cleaning
Unplug the appliance and let it cool down for about 15 minutes before you clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1
Clean the lamp housing and the base with a moist cloth. Do not let any water run into the
appliance.
2
You can clean the outside of the filter with a soft cloth sprinkled with some methylated
spirits.
storage
Do not let the mains cord come into contact with the filter when it is hot.
1
Unplug the appliance and let it cool down for about 15 minutes before you store it.
- Always lift or carry the appliance by its handgrip (Fig. 13).
2
Store the InfraCare in a dry place.
EnglisH
9