Philips SPN5087B/10 Quick Setup Guide

Additional information about your energy efficient surge protector 

 

Features 

Your energy efficient surge protector is specifically designed to fit within 

your home theater setup.  You can conveniently control the on/off of your 

devices in either zone 1 or zone 2 outlets with your remote control.  When 

switched to the off position, it eliminates the consumption of the stand-by 

power to these outlets, bringing energy savings to your fingertips. 

Zone 1 & 2 outlets group your devices by usage.

Always on outlets remain on even when other outlets are switched off 

– these are ideal for devices which have volatile memory and require 

constant power. (i.e. cable modems, DVRs , set top boxes, etc) 

Remote control turns your devices on/off in zone 1 & zone 2 with the 

touch of a button.

Cable management clips help eliminate cable clutter.

LED indicators on the front of the unit provide worry-free protection and 

show that your surge protector functions properly.  

Power – (blue) shows that the power is running to your devices.
Protecting – (red) shows that your surge protector is actively 

protecting your devices.
Zone 1 & Zone 2 – (green) lights to show that the group of outlets 

have been switched on. 

 

 

Instructions for changing the remote control battery

NOTE: If the remote control device stops working, replace the battery. 
Step 1 - Turn the unit over and slide open the battery compartment cover.
Step 2 - Remove and dispose of the old battery properly. Do not throw the old 

battery in the trash.

Step 3 - Insert a new battery and close the compartment cover.  Replace ONLY 

with a 3 volt CR2032 type button cell battery.

NOTE: The remote control with this unit operates on either channel A or channel B frequency. If you have purchased 

more than one unit, make sure you have two different frequencies (A and B) as indicated by stickers on the bottom of 

the unit and on the packaging.

FCC ID: OYMSPP5107C

RF Remote Contro

l

harmful interferen

ce,and

This device may not cause

 

This device must accept an

y

interfe

rence that may cause 

undesired operatio

n

Oper

ation is subject to the 

interfe

rence

 received,including 

following two conditions

:

This device complies with

 part 

15 of the FCC Rules.

(1)

(2)

Made in Chin

a

Ch. A

POWER

PROTECTING

ZONE 1

ZONE 2

Zone 2

Zone 1

Always on 

Cable management clips

Remote control

EN