Indesit IDV75BK(UK) User Guide

Instruction booklet

Open the door of your dryer

Pull out the filter (using the 

two finger grips)

Clean the fluff off the filter 

and replace it correctly. 

Ensure that the filter is 

pushed fully home.

Make sure the filter is pushed fully home

NEVER 

run the dryer without the filter in  position

Failure to clean the filter after EVERY drying 

cycle will affect the drying performance of your 

machine. It will take longer to dry and as a result 

will use more electricity during drying.

At least every two or three months you MUST 

clean fluff build up around the filter housing and 

the vent tube. 

10

 m

m

15 mm

15 mm

15 mm

15 mm

If you are going to install the 

appliance under a work 

counter be sure to leave a 

10 mm space between the 

top and any other objects on 

or above the machine and a 

15 mm space between the 

sides and any kitchen units 

or walls to ensure proper air circulation. The 

dryer must never be installed behind a lockable 

door, a sliding door or a door with a hinge on the 

opposite side to that of the dryer door.

The appliance must be installed with the rear 

surface placed against a wall

.

When the dryer is in use there has to be adequate 

ventilation to avoid the back flow of gases into 

the room from appliances burning other fuels, 

including open fires. 

The vent tube should not exceed 2.4 

metres in length. The tube should be kept clear of the air intake 

vent and kinks or ‘U’ bends must be avoided as these will obstruct 

the tube and trap condensation. 

Keep the tube as short and as straight 

as possible to prevent condensation 

forming in the vent pipe.

The duct in the wall should slope 

slightly downwards.

The hole in the window should be as 

low down as possible and the tube should be kept as short as 

possible.Depending on how often you use your tumble dryer, it is 

essential that areas 

 and 

 are checked periodically to remove 

lint or debris. 

 This symbol reminds you to read this booklet.

B

A

The end of the tube should be 

directed downwards, to prevent 

warm moist air from condensing in 

the room or dryer.

Do not discharge exhaust 

air into a flue which is used 

for exhaust fumes from 

other appliances that burn gas or other fuels. 

Do not discharge exhaust air into an extraction system or any duct 

with an extractor fan. This will affect the way the thermal controls 

operate and can result in a fire hazard.

The socket must be grounded. The power supply 

cord should be checked periodically. If the 

supply cord is damaged, it must be replaced by 

the manufacturer, its service agent or similarly 

qualified persons in order to avoid a hazar

The dryer must be installed level for 

correct operation. When you have 

installed your dryer in its final location 

check that it is first level side to side and 

then back to front.

If the dryer is not level use a wooden 

block to support it while adjusting the 

two front legs up or down until your dryer is level.

Once you have installed your dryer and before you 

use it clean the inside of the drum to remove any 

dust that could have accumulated during transport

.

Air intake vent 

Do not block or obstruct

Caution: Hot!

Vent Tube fitted here