Indesit XWDA751680XW UK User Guide

Levelling the machine correctly will provide 

it with stability, help to avoid vibrations and 

excessive noise and prevent it from shifting 

while it is operating. If it is placed on carpet or 

a rug, adjust the feet in such a way as to allow 

a sufficient ventilation space underneath the 

Washer-dryer.

1. Connect the inlet 

hose by screwing it 

to a cold water tap 

using a 3/4 gas thre-

aded connection (see 

Before performing the 

connection, allow the 

water to run freely un-

til it is perfectly clear.

2. Connect the inlet 

hose to the Washer-

dryer by screwing it 

onto the correspon-

ding water inlet of the 

appliance, which is 

situated on the top 

right-hand side of the 

rear part of the ap-

pliance (see figure).

3. Make sure that the hose is not folded over 

or bent.

! The water pressure at the tap must fall within 

the range of values indicated in the Technical 

data table (see next page).

! If the inlet hose is not long enough, contact a 

specialised shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

! This instruction manual should be kept in a 

safe place for future reference. If the Washer-

dryer is sold, transferred or moved, make sure 

that the instruction manual remains with the 

machine so that the new owner is able to fa-

miliarise himself/herself with its operation and 

features.

! Read these instructions carefully: they con-

tain vital information relating to the safe instal-

lation and operation of the appliance.

Unpacking
1. Remove the Washer-dryer from its packaging.

2. Make sure that the Washer-dryer has not 

been damaged during the transportation 

process. If it has been damaged, contact the 

retailer and do not proceed any further with 

the installation process.

3. Remove the 4 pro-

tective screws (used 

during transportation) 

and the rubber wa-

sher with the cor-

responding spacer, 

located on the rear 

part of the appliance 

(see figure).

4. Close off the holes using the plastic plugs 

provided.

5. Keep all the parts in a safe place: you will 

need them again if the Washer-dryer needs to 

be moved to another location.

! Packaging materials should not be used as 

toys for children.

Levelling
1. Install the Washer-dryer on a flat sturdy flo-

or, without resting it up against walls, furniture 

cabinets or anything else.

2. If the floor is not 

perfectly level, com-

pensate for any une-

venness by tightening 

or loosening the 

adjustable front feet 

(see figure); the angle 

of inclination, measu-

red in relation to the 

worktop, must not 

exceed 2°.