Indesit XWE91683XWWG User Guide

! This instruction manual should be kept in a safe 

place for future reference. If the washing machine 

is sold, transferred or moved, make sure that the 

instruction manual remains with the machine so 

that the new owner is able to familiarise himself/

herself with its operation and features.

! Read these instructions carefully: they 

contain vital information relating to the safe 

installation and operation of the appliance.

Unpacking
1. Remove the washing machine from its 

packaging.

2. Make sure that the washing machine has 

not been damaged during the transportation 

process. If it has been damaged, contact the 

retailer and do not proceed any further with 

the installation process.

3. Remove the 4 

protective screws 

(used during 

transportation) 

and the rubber 

washer with the 

corresponding 

spacer, located on 

the rear part of the 

appliance (see figure).

4. Close off the holes using the plastic plugs 

provided.

5. Keep all the parts in a safe place: you will 

need them again if the washing machine 

needs to be moved to another location.

! Packaging materials should not be used as 

toys for children.

Levelling
1. Install the washing machine on a flat sturdy 

floor, without resting it up against walls, 

furniture cabinets or anything else.

2. If the floor is 

not perfectly level, 

compensate for 

any unevenness 

by tightening or 

loosening the 

adjustable front 

feet (see figure); the 

angle of inclination, 

measured in relation 

to the worktop, must 

not exceed 2°.

Levelling the machine correctly will provide 

it with stability, help to avoid vibrations and 

excessive noise and prevent it from shifting 

while it is operating. If it is placed on carpet or 

a rug, adjust the feet in such a way as to allow 

a sufficient ventilation space underneath the 

washing machine.

1. Connect the supply 

pipe by screwing it to 

a cold water tap using 

a ¾ gas threaded 

connection (see 

Before performing 

the connection, allow 

the water to run freely 

until it is perfectly 

clear.

2. Connect the 

inlet hose to the 

washing machine by 

screwing it onto the 

corresponding water 

inlet of the appliance, 

which is situated on 

the top right-hand 

side of the rear part 

of the appliance (see 

figure).

3. Make sure that the hose is not folded over 

or bent.

! The water pressure at the tap must fall within 

the values indicated in the Technical details 

table (see page 5).

! If the inlet hose is not long enough, contact a 

specialised shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.