Indesit IDCE8450BS User Guide

Failure to clean the filter after each drying cycle

can undermine drying performance as the machine

takes longer to dry and thus consumes more

energy.

Water container – empty the water container after

each drying cycle.

Step 1
Pull the water container towards
you and remove it completely
from the dryer.

Step 2
Empty all the water in the water
container.

Step 3
Replace the water container
making sure that it is securely
fixed.

Failure to empty the water container may cause the

following:

- The dryer stops heating (thus the load may still be

damp at the end of the drying cycle).

- The “Empty water container” LED activates to
show that the water container is full.

Filling of the Water Container

When the dryer is first used water will not

immediately enter the water container as the pump

needs to be primed. This is done automatically

and will take a few minutes, during this period the

efficiency of the drying process is not affected.

Important information

To ensure that the condenser dryer functions

efficiently, the following routine maintenance

procedures must be carried out:

Fluff filter – CLEAN off any fluff build-up on the

filter after each drying cycle.

Step 1
Open the dryer door by pressing
it as shown in the picture.

Step 2
Pull out the filter (using two
fingers).

Step 3
Clean off any fluff build-up on the
internal surface of the filter.

Step 4
Replace the filter – never operate
the dryer without the filter in
place.