Jacuzzi J-345 User Manual

34

No filtration

Maximum of a half hour per day

10 minutes of filtration 

every 12 hrs

Maximum of a half hour every 12 hrs 

(after secondary cycle ends)

10 minutes of filtration 

every 8 hrs

Maximum of a half hour every 8 hrs 

(after secondary cycle ends)

10 minutes of filtration 

every 6 hrs

Maximum of a half hour every 6 hrs 

(after secondary cycle ends)

To activate the Economy Mode, follow the steps below.

A.  Press the 

Menu ( 

 ) button four times to display the Economy 

Menu (Figure 8). The LED screen will display “ECO.”

B.  Press the 

Warmer (   ) button to enter the menu. The LED screen 

will display the current status of the Economy Mode setting, either 

ON or OFF.

C.  Press the 

Warmer (   ) button to scroll through the settings.

D.   Once the new setting appears of the display, press the 

1 ( 

 ) button to confirm your selection (Figure 9). The display of 

the LED screen will blink twice to indicate that the change has been 

accepted. You must press the 

Jets Pump 1 ( 

 ) button to confirm 

your selection or the current settings will remain active.

Note: If no button is pressed within 5 seconds of each selection the 

screen will revert back to the Main Menu and the current settings will 

remain active.
11.9 

The Lock menu gives you the option to lock specific features of the spa. 

There are three locking modes, L1, L2 and L3.

Note: When a lock mode is active, the LED display will flash between the 

lock mode and temperature.

L1 lock mode: The jets pumps and heater are deactivated. This mode 

can be used when replacing or cleaning the spa filters.

Note: The spa should not be left in this lock mode for an extended period 

of time. Especially in colder climate or when freezing conditions exist.
L2 lock mode: The jets pumps, adjust temperature and CLEARRAY 

buttons are deactivated. This mode can be used to 

prevent unauthorized use of the spa.

►

◄

◄

▲

◄

◄

▼

◄

◄

◄

Figure 8

Figure 9