Multi-Tech Systems MVP-2410 User Manual

37 

4. If you intend to configure the MultiVOIP remotely using the 

MultiVOIP Windows GUI, connect an RJ-11 phone cable between the 

Command Modem connector (at the rear of the MultiVOIP) and a 

receptacle served by a telco POTS line.  See Figure 3-6.   
The Command Modem is built into the MultiVOIP unit.  To configure 

the MultiVOIP remotely using its Windows GUI, you must call into 

the MultiVOIP’s Command Modem.  Once a connection is made, the 

configuration process is identical to local configuration with the 

Windows GUI. 

Telco POTS Line

Grounding Screw

 

5. Ensure that the unit is properly connected to earth ground by 

verifying that it is reliably grounded when mounted within a rack.  
This can be accomplished by connecting a grounding wire between 

the chassis grounding screw (see Figure 3-6) and a metallic object that 

will provide an electrical ground. 

6. Turn on power to the MultiVOIP by setting the power switch on the 

right side panel to the ON position.  Wait for the Boot LED on the 

MultiVOIP to go off before proceeding.  This may take a couple of 

minutes. 

Proceed to Chapter 4 “Software Installation.”