Cetacea Sound was-pd2-owl Quick Setup Guide

 

 

 

Model No. WAS-PD2-OWL 
Model No. WAS-PD3-OWL 

 

1. 

There are three (3) source-input plugs on the Walk Around 

Sound (WAS-PD3) and two (2) source input plugs on the (WAS-PD2) 
amplifier base that can accept either mono or stereo inputs depending on 
your “source”, i.e., computer, VCR, DVD, VCD, etc.  
2. 

The WAS-PD2 is identified by the 2 inputs and one line output 

marked “output”. Be sure not to use the “output” as an input, it has a 
special application.  
3. 

In order to connect to the amplifier, use a single male-to-male 

extension similar to the one supplied with your system accessories. One 
end will fit the source “output” and the other will plug directly into one 
of the WAS-PD inputs labeled A, B, or C, depending on your model. 
Refer to the hook-up drawings on your specification sheet if you have 
questions.  
4. 

Do not adjust the volume on the “sound source” above 75 %, 

because computers, VCR’s, and CD players exhibit distortion at high 
volume levels.  
5. 

Turn the volume down as low as it will go (counter-clockwise) 

on your WAS-PD amplifier (the large disk on top with the finger 
dimple). 
6. 

If your sound source has a “BASS BOOST”, or special effects 

like Spatializer, SRS, or controls that say “JAZZ”, “ROCK”, “BLUES”, 
etc., turn them off for now! Also turn off all computer DSP’s. 
7. 

The WAS-PD amplifier requires power from the “Switchable 

Power Supply”. Plug the power supply into a suitable source of power 
(100-240v) and the opposite small end into the base of the WAS-PD 
amplifier. (It will only fit in one location.) 
8. 

Plug the speaker cables into the left and right output jacks on the 

WAS-PD. Turn on the sound source and slowly turn up the volume on 
the WAS-PD. Be sure to use a high quality recording to fully appreciate 
the awesome sound of the speakers. See instructions on other side for 
mounting OWLs to the wall. 
 

(OVER)

 

5RMF-WASPD(2)(3).doc