GE psb1000n Installation Instruction

— Save these instructions

for local inspector’s use.

— Observe all governing

codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with the Consumer.

• Note to Consumer – Keep these instructions for

future reference.

• Skill level – Installation of this appliance requires

basic mechanical and electrical skills.

• Completion time – 1 hour

• Proper installation is the responsibility of the

installer. 

• Product failure due to improper installation is not

covered under the Warranty. See Owner’s
Manual for warranty information

.

• Use this oven only for its intended purpose.
• Never use the oven for warming or heating a

room. Prolonged use of the oven without proper
ventilation can be hazardous.

™ 

For personal safety, remove house fuse or oven
circuit breaker before beginning installation to avoid
severe or fatal shock injury.

For personal safety, the mounting surface must be
capable of supporting the cabinet load, in addition 
to the added weight of the 75-pound product, plus
additional oven loads of up to 50 pounds or a total
weight of 125 pounds.

For personal safety this product cannot be 
installed in cabinet arrangements such as an island,
a peninsula or below a countertop.

Design Information
Models Available .................................................................... 2
Product Dimensions and Clearances .......................... 2
Tools Required ........................................................................ 2
Parts Supplied  ........................................................................ 2
Advance Planning  ................................................................ 3 

Installation Preparation 
Electrical Requirements  .................................................... 4
Prepare the Opening  ...................................................... 5, 6
Remove the Packaging ...................................................... 6

Installation Instructions
Step 1, Slide the Oven into the Cutout ........................ 7
Step 2, Install Bottom Trim ................................................ 7
Step 3, Install Mounting Screws ...................................... 8
Step 4, Finalize Installation................................................ 8