Fujitsu dl-3750 User Manual

USING SETUP MODE

User's Manual

5-48

<<FUNCTION>>

  SAVE&END  MENU1  MENU2  HARDWRE  ADJUST  CONFIG  DEFAULT  LIST  SELF-TST  HEX-DUMP

  V-ALMNT

2. Select the SAVE & END function.

Make sure that the red cursor is positioned under SAVE & END.

Press the MENU button or the TEAR OFF button to select SAVE &

END.  The printer exits setup mode and returns online (the ONLINE

indicator lights green).  Any changes you made while in setup mode

are saved.

This section describes how to exit the setup mode save any changes you

made:

To exit setup mode immediately, select the SAVE & END function.

Any settings changed while in setup mode are saved as the new power-on

defaults for the printer.  The new defaults remain active until you change them

again.

To exit setup mode and save your changes using SAVE & END, proceed as

follows:

1. Print the <<FUNCTION>> menu.

The <<FUNCTION>> menu should be the last printed line on the

page.  If the menu is not printed, press the ONLINE button to print the

menu.  If you are using the SELF-TST or HEX-DUMP function, press

the LF/FF button instead of the ONLINE button to print the menu.

The <<FUNCTION>> menu is shown below.