Fujitsu fi-4120C Installation Instruction

Fujitsu SCSI Scanner Installation Procedures 

Windows NT 4.0 

 

Rev051906A 

 

Page 1 of 9 

If you are installing the following models by means of the SCSI interface then use this 
document. 
 
SP10C 

 

 

 

 

If you are going to use the USB interface of a dual SCSI/USB model then use the USB scanner 
installation guide.  For Scansnap models please use the Scansnap installation guide.   
 
 
Hardware requirements. 
 
You will need a PC system that meets our recommended specifications, an appropriate SCSI 
controller, and a SCSI cable (six foot recommended maximum).  For recommended PC system 
specifications and SCSI controllers please reference the 

You may also need your Operating System Disk.

 

 

 

Step A:  Installing the SCSI Host Adapter (Adaptec). 
 

1.  Shut down your PC and remove the case cover. 
2.  Locate a free PCI slot and remove the back plate if necessary. 
3.  Install the SCSI controller in an open PCI slot. 
     Make sure that the card is seated completely in the slot and secured in the frame 
 
Warning!  Failure to secure the SCSI controller in the PC can result in damage to the 
SCSI card, scanner, and/or your system. 
 
4. Boot your PC without the scanner attached

. 

 
 
 
 
 
 
 
 
 
 
 
 
Step B:  Installing the SCSI drivers (Adaptec). 
 
Although Windows NT has driver support for your host adapter it does not support plug and 
play.  Therefore the SCSI drivers will need to be loaded manually.  Follow the instruction below 
to install the driver for your host adapter.