Küppersbusch ekwe320s Installation Instruction
14
Installation instructions - EKWE/EKWH - USA
– Place a metal pan on the respective cooking zone for a short time.
The honeycomb touch control on the control honeycomb stops flashing and a
number is indicated on the LED display.
The next honeycomb touch control on the control honeycomb will start
flashing. The “E” indicated on the LED display is irrelevant.
number is indicated on the LED display.
The next honeycomb touch control on the control honeycomb will start
flashing. The “E” indicated on the LED display is irrelevant.
– Once again place a metal pan on the respective cooking zone for a short time.
Repeat this procedure until you have worked through all of the touch
controls and none of them flash.
controls and none of them flash.
Note:
Should, on commencement of allocation, an “E” appear in an LED display
other than that of the flashing honeycomb touch control, an error has occurred
in the pan detection for this cooking zone. Touching the clock sensor will
enable this honeycomb to be skipped when it is the next one to be processed
and will still enable configuration to be continued.
other than that of the flashing honeycomb touch control, an error has occurred
in the pan detection for this cooking zone. Touching the clock sensor will
enable this honeycomb to be skipped when it is the next one to be processed
and will still enable configuration to be continued.
Allocating power control to the cooking zones
No pans or any other metal objects may be located on the cooking zone
when carrying out the following step since this could result in problems
with the pan-on detection.
Since the cooking zones will become hot during the following step, all
inflammable objects must be removed. Risk of burning!
when carrying out the following step since this could result in problems
with the pan-on detection.
Since the cooking zones will become hot during the following step, all
inflammable objects must be removed. Risk of burning!
– Touch the key sensor to confirm the assignment of the pan detection
function.
One of the cooking zones will begin to heat up. You will recognize this since
the cooking zone will glow dark red.
the cooking zone will glow dark red.
– Once you have recognized this glowing, touch the plus sensor on the
control honeycomb for this particular cooking zone.
The number which appears on the respective LED display is the number
of the plug connection and is of no significance for you.
The number which appears on the respective LED display is the number
of the plug connection and is of no significance for you.
– To confirm accuracy, touch the clock sensor on the minute minder.
The confirmed cooking zone will stop heating and the next cooking zone will
be heated up.
be heated up.
– Touch the respective plus sensor for this cooking zone on the control
honeycomb again and confirm by means of the clock sensor.
Carry out this procedure six times.
Carry out this procedure six times.
Instructions for connecting fewer than 6 cooking zones
If fewer than 6 cooking zones are connected, connections on the power
module will remain unused. Of course no cooking zone will glow should these
be activated by the electronics system. So if no cooking zone lights up this
must be acknowledged by touching the clock sensor of the minute minder.
module will remain unused. Of course no cooking zone will glow should these
be activated by the electronics system. So if no cooking zone lights up this
must be acknowledged by touching the clock sensor of the minute minder.
– Once the last assignment has been carried out, confirm by touching the
key sensor.
The configuration data will now be stored permanently in the electronics
system.
system.
In the event of an error or alterations to the arrangement, the procedure can
easily be carried out from the beginning again and the settings altered.
easily be carried out from the beginning again and the settings altered.
The final step is automatic calibration of the pan-on detection. The LED
displays will indicate “
displays will indicate “
'%0”.
Once this display has switched off the honeycomb can be
XVHG