APC Smart-UPS VT SUVTP15KH2B4S User Manual
Product codes
SUVTP15KH2B4S
2
Caution: Ensure that the floor is level. The enclosure
cannot be installed on a floor that is not level.
cannot be installed on a floor that is not level.
Space considerations
Note: Allow for enough working space behind the
enclosure for electrical work to be carried out (e.g. if you
want to connect an XR Battery Enclosure at a later stage).
enclosure for electrical work to be carried out (e.g. if you
want to connect an XR Battery Enclosure at a later stage).
10-20 kVA.
10-40 kVA.
* All physical installations must comply with local standards.
Unpacking
Unpack the enclosures
Caution: Do not unpack the units before the time of the
installation.
installation.
Note: If the system is not being installed immediately, do
not remove the packaging. Store the system in an indoor,
temperature-controlled area, free of conductive contaminats.
not remove the packaging. Store the system in an indoor,
temperature-controlled area, free of conductive contaminats.
Heavy: There must be two people to roll the enclosure from
the pallet.
the pallet.
Note: Save four bolts for attaching the stabilizing brackets
to the 352 mm (13.85 in) enclosure. See “Stabilizing
Brackets” .
to the 352 mm (13.85 in) enclosure. See “Stabilizing
Brackets” .
Land packaging.
Front-to-rear
airflow
Floor-to-ceiling
ventilation:
523 mm
(20 in)
Minimum
front clearance:
Minimum
rear
clearance*:
828 mm
(32.99 in)
100 mm
(4 in)
356 mm
(14 in)
1000 mm
(39.3 in)
Enclosure
356 mm
(14 in)
Front-to-rear
airflow
Floor-to-ceiling
ventilation:
523 mm
(20 in)
Minimum
front clearance:
Minimum
rear
clearance*:
828 mm
(32.99 in)
100 mm
(4 in)
559 mm
(22 in)
1000 mm
(39.3 in)
Enclosure
559 mm
(22 in)
Cut carefully along the
edges to remove the plastic
and to free the ramp.
and to free the ramp.
Place the ramp by aligning
the velcro strips on the ramp
with the velcro strips on the
front edge of the pallet.
with the velcro strips on the
front edge of the pallet.
Remove the cardboard
cover.
Remove the corner
protection and the plastic bag.
Remove the bolts from the
brackets attaching the
enclosure to the pallet and
save the brackets for floor
anchoring, if required.
enclosure to the pallet and
save the brackets for floor
anchoring, if required.
Roll the unit off the pallet.
Ramp