Mitsubishi 56p-qf60lcu User Manual
EN-9
Connections
Before making connections:
• First turn off the power of all the attached equipment and make connections.
• Refer to the user manual included with each separate piece of equipment.
• Refer to the user manual included with each separate piece of equipment.
DVI-D cable
Computer
56P-QF60LCU
(Rear panel)
(Rear panel)
DVI-D
INPUT1
INPUT2
INPUT3
INPUT4
DVI-D
Recommended video signal timing for this product is as follows.
Resolution
Frequency
Notes
Horizontal
Vertical
1920×1080
67.5 kHz
60 Hz
Each of INPUT 1 to 4 connectors
• To display images at a resolution of 3840x2160, input 1920x1080 signal to each of INPUT 1 to 4 connectors.
• The image of 2544x1080 signal can not display correctly.
• Images may not be displayed correctly depending on the type of video card or driver.
• Signals input to INPUT 1 to 4 connectors are laid out on the screen as follows.
• The image of 2544x1080 signal can not display correctly.
• Images may not be displayed correctly depending on the type of video card or driver.
• Signals input to INPUT 1 to 4 connectors are laid out on the screen as follows.
Connect the power cord
1. Insert one end of the power cord into the power input connector of this product.
Insert it as far as it will go.
2. Clamp the power cord using the clamper.
3. Plug the power cord in a wall outlet.
3. Plug the power cord in a wall outlet.
• The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible.
• Fully insert the prongs into the power outlet socket. Loose connection may cause noise.
• Fully insert the prongs into the power outlet socket. Loose connection may cause noise.
INPUT
1
INPUT
3
INPUT
2
INPUT
4
POWER
Clamper