Mitsubishi lt-3280 Owner's Manual

Press GUIDE while viewing the Record To screen to see a 
list of all currently programmed recordings.  A maximum of 
32 recordings can be scheduled. 

To cancel a recording in progress, press DEVICE to 

display the Device Selection menu and highlight the 
source of the recording.  Confirm that the icon for VCR (or 

recording device) is in the Connection Section next to the 

TV icon. Press the CANCEL button.  The icon for the VCR 

(or recording device) will disappear from the Connection 
Section to confirm the cancellation. 

To cancel a recording on the Record List, press ADJUST 

 or 

 to select the recording, then press CANCEL.  To 

page through the list, press CH  

 or 

.

A peer-to-peer connection allows the IEEE 1394 devices 

in your media center network to talk to each other without 
the further need of media center intervention once the 
peer-to-peer connection is established.  For example, the 
media center can set up a connection for an  or DVCR 
that sends a recorded program to an IEEE 1394 monitor in 
another room.  NetCommand will establish the connection 
between the two devices.  Once the connection has been 
established, the media center can be turned off or be 
used to display another device on the monitor.  Recording 
from digital channels to a DVCR is also a peer-to-peer 
connection.  In this case, the media center is one of the 
devices in the peer-to peer connection.

NOTE:  Multiple peer-to-peer connections can occur 
simultaneously, sometimes with the same source device. 

To establish a peer-to-peer connection:

1.  Press CONNECT on the HDTV remote.

2.  Press DEVICE on the remote control to move to the 

Source Device section.

3.  Press ADJUST    or   to select the source device you 

will record from.

4.  Press ENTER  to confirm selection and return to the 

“Record to” section.    

5.  In the “Record to” section, review the destination 

device (example: DVCR) and duration.  Change if 

necessary.

5.  Press CONNECT a second time to initiate recording.

After a peer-to-peer connection has been established, 

you can cancel it by highlighting the source device in 
the Device Selection menu.  Confirm that the on-screen 
icon for the peer-to-peer connection is in the Connection 
Section next to the TV icon, then press  CANCEL.  The 
connection will end and the destination icon will be 

removed.  If there is more than one peer-to-peer 

connection for the same device, all of the connections will 
all be canceled.