Mitsubishi lt-3280 Owner's Manual

36.

All IEEE 1394 devices disappear.

• The connected devices must not be in a loop that returns to the
   media center.  Make sure a device is connected at the end. 
• Disconnect all the cables and devices from the TV.  Replace them one
   by one to locate the problem device or cable.  
• Use System Reset (front control panel).

37.

Cannot rediscover a deleted IEEE 1394 device

• The device has been disconnected.  Plug it in.
• The device is unchecked in the Review screen.  Select NetCommand
   from the Main menu, then select Review.  Check the device.
• Remove IEEE 1394 plug.  Go to the Edit NetCommand menu.  Delete
   the IEEE 1394 device.  Plug the device in again so it can be
   discovered again.

38.

An IEEE 1394 device has been plugged in but  
does not appear in the Device Selection menu 
(not discovered).

• The IEEE 1394 connection to the media center or another device is 
  not secure or is loose.
• The IEEE 1394 device is not powered on.
• A device in the IEEE 1394 chain is not powered on - turn on all the
   devices.
• The device discovery can take as long as a minute to initiate.
• IEEE 1394 cable is too long (maximum of 15 feet  between devices).
• The IEEE 1394 device uses an incompatible protocol and will not be
   discovered

39.

Cannot record to or from the IEEE 1394 device,
 including Dub recordings.

• To initiate a recording to IEEE 1394 device press the REC key.
   The Record menu displays allowing setup of the recording.
• The source device for the recording is not powered on.
• When dubbing, the destination device for the recording
   is not powered on.
• The wrong media, (analog tape for digital recording, or
   digital tape for the analog recording) is in the device.
• Either the program is copy protected, or if there are multiple
   subchannels and one of the programs (not necessarily the
   program requested) is copy protected.
• The program has already been recorded once and the copy
   protection only allows one recording.
• Unapproved source device for copy protected material.
• The recording device can not decode the copyright signal
   included in the signal source (try another device if available).
• The playing device (for dubbing) does not support
   copyrighted material.
• Source for recording is copyrighted.  
• Too many IEEE 1394 devices in network. Insufficient
   bandwith available.  Disconnect unused devices.
• Source Device has higher speed (S 400) than record device.  If
   possible, reverse devices, play in the slower device and record
   in the faster device.

40.

Cannot control the IEEE 1394 device from the
Transport Menu.

• Device may not support the command.
• Selected function is gray (such as Record for a DVD, which does not
   support the Record function).

41.

When ChannelView™ list is displayed,
information appears incomplete.

•  Available information is sent from the broadcaster or cable provider. 
    No other data is available.

42.

Program to be recorded was correctly selected
from ChannelView, however, incorrect program
was recorded.

•  The broadcaster supplied program information that was incorrect
     and/or was changed after a recording was added to the Record List.

43.

Incomplete ChannelView program recorded.

•  Recording device may have lack of space availability and there is not
    enough blank space to make a full recording.