Norcent dp2700 Quick Setup Guide

QUICK OPERATION SHEET

DVD R

VD Receiv

eceiver

DP2700

STEP 2: Turn on television.
This Norcent DVD Player may be operated

either by the buttons on the unit's front panel or

by the included remote control.

STEP 4: Press the STANDBY/ON button located

on front panel of Home theater.

STEP 5: Press

" OPEN/CLOSE "

button. Disc

tray will open.

STEP 6: Place disc on tray with playback side

face down.

STEP 7: Press

" OPEN/CLOSE"

button. Tray

will close. The player will automatically

read the disc and begin playing in

approximately five seconds.

STEP 8: Insert the two included

AAA

batteries

into remote control. Make sure + and - on

batteries match up with + and - inside

remote battery compartment.

STEP 9: Point remote control at remote sensor

located on front panel of player.

Note: The remote control is operational at a

maximum distance of 21' from sensor at an angle

up to 30 either side.

See the User's Manual for directions on how to

operate the unit's many special features,

such as the parental lock function.
To ensure proper use of this product, it is

important that you carefully read the user's

manual, especially the information regarding

safety and precautionary measures.

STEP 3:Switch your TV into video input mode.

This will be usually a button on your

TV remote that is labeled INPUT or

TV/VIDEO, Line Input, AV Input or

Source. If you have trouble to locate

the Video Input Mode button, please

consult your TV operation manual.

* If your TV doesn't have Video Cable Input, you

need to purchase a RF Modulator from your local

electronics retailer.

TV Video input

STEP 1: Following the diagram below, connect the Yellow, White and Red cables from the back panel

of the DVD player directly to the Television correspondingly*

TV Audio input

L R

PROG

SOU RCE

PROG

SOU RCE

button is pushed

Activating P/I (Progressive/Interlace) Mode

If your TV has component input terminals (YPRPB or YCbCr), you can connect your TV to this DVD player's

component output terminals (YPRPB) using component signal cables (not provided). Please select the

YPRPB in the General setup video out - YPRPB in order to obtain a clear picture.

Use your TV remote control or control buttons at the front of your TV to select component input as your TV's

input signal.

Press P/I button on the DVD player's remote control to switch between progressive and interlace mode. Older

TV system only supports interlace mode, but newer TV system supports progressive mode.