Soleus kfhhp-22 User Guide

 

- 14 -

 
 
 
               

◆Installation 

 

 

 

 

1.  Always mount the rear panel horizontally.  Because the mouth of drainage pipe is at the left side 

and the left side of the rear panel is better to adjust 
slightly lower. 

2.  Fix the rear panel on the selected location with 

screws supplied with the unit. 

3.  Be sure that the rear panel has been fixed firmly 

enough to withstand the weight of an adult of 
132.3 lbs; furthermore, the weight should be evenly 
shared by each screw. 

 
 
 

 

 

1.  Make the piping hole （Φ65） in the wall at a slight downward slant to the outdoor side. (Shown 

in Fig.1) 

2.  Insert the piping-hole sleeve into the hole to prevent the connection piping and wiring from being 

damaged when passing through the hole. 

 
 
 

 

 

1.  For well draining, the drain hose should be placed at a 

downward slant. 

2.  Do not wrench or bend the drain hose or flood its end by water. 
3.  The extended drainage pipe in the room should be wrapped with 

the insulating materials. 

 
 
 

 

 

Connect the connection pipes with the relevant union pipes of the indoor unit and tighten the flare nut 
of the connection pipes (Shown in P19 “Install the connection pipes”). 

 

 

 

 

Connect the connection pipes with the indoor unit firstly and the outdoor unit secondly. 

 

Be careful in bending the connection pipes, or you will damage the pipes. 

 

If the tightening torque is too great is tightening the flare nuts leakage will happen. 

 
 
 

 

 

1.  The power supply should adopt the rated voltage and special circuit. 
2.  Wiring must be done by special technician according to local rules, regulations and the manual. 
3.  The nut should be tightened and cannot fall off.