Enterasys mrx Installation Instruction
Page 3-8
INSTALLATION
3.3.3 Free-Standing Installation
For a free-standing installation, locate the HUB within 7 feet of its
power source and with an unrestricted free surface area 21 inches
wide, 18 inches deep and 6 inches high.
power source and with an unrestricted free surface area 21 inches
wide, 18 inches deep and 6 inches high.
Figure 3-6. Shelf or Table-top Installation
3.4 CONNECTING THE HUB TO THE POWER SOURCE
Connect the HUB to the power source as follows:
NOTE: The HUB has a universal power supply. This allows you to
connect the HUB to power sources from 85 Vac to 264 Vac, 47-63Hz.
connect the HUB to power sources from 85 Vac to 264 Vac, 47-63Hz.
1.
Plug the power cord (see Figure 3-6) into the power receptacle
located on the rear of the HUB.
located on the rear of the HUB.
2.
Plug the power cord into a grounded wall outlet.
After you have made the power connection, verify that the POWER
LED is lit, indicating that the HUB is receiving power.
LED is lit, indicating that the HUB is receiving power.