ASKProxima c440 User Manual

: allows adjustments to the Balance and Volume. Also allows you to 

turn on and off the Internal speakers, and projector startup Chime.

: 

allows you to assign a particular input to a specific source key 

when using the Integrator remote. Also allows selection of a default Startup 
Source and enables or disables Autosource. 

this determines which source the projector 

checks first for active signal during power-up. 

When Autosource is not checked, the projector 

defaults to the source selected in Powerup Source. If no source is found, a 
blank screen displays. When Autosource is checked, Powerup Source deter-
mines which source the projector defaults to at power-up. If no signal is 
present, the projector checks the sources in order until a source is found or 
until power down. 

reverses the image so you can project from behind a 

translucent screen.

: turns the image upside down for ceiling-mounted projection.

IR Receivers: 

turns individual IR receivers off or on to avoid environ-

mental interference.

: When Auto Power is checked, the projector automatically 

goes into the startup state after the projector is powered on. This allows 
control of ceiling mounted projectors with a wall power switch.

: displays status messages (such as “Searching” or 

“Mute”) in the lower-left corner of the screen.

: toggles between on and off. Turn it on to lower the light out-

put of the lamp. This also lowers the fan speed, making the projector qui-
eter.

NND: 

prevents your notebook computer from going into Screen Save 

mode (functions only when the USB connector is plugged in).

: automatically turns the lamp off after no signals are 

detected for 20 minutes. After 10 additional minutes with no signal, the 
projector powers down. If an active signal is received before the projec-
tor powers down, the image will be displayed. 

Audio

Settings
menu

Sources

Powerup 
Source

System 

IR Receivers

IR Receivers