ASKProxima impression 1280 User Guide

The following steps will quickly lead you through set-up and adjustments.
The sequence numbers refer to the drawing on the rear of the quick set-up.
For details, please consult the following chapters.

POWER OFF (1)
Switch off all equipment before
connecting.

COMPUTER/ (2)
Connect the computer to the
COMPUTER input using the GA-
cable (Graphics Adapter)  and
applicable computer and monitor
adapters if needed.

WORKSTATION (3)
Disconnect your GA cable at the
monitor end, and connect it to the
short branch of the BNC cable. The
long branch connects to your
monitor.

MOUSE (4)
Connect the mouse cable to the
MOUSE connector of the projector.
Use an applicable mouse adapter
at the computer end.

MAINS (5)
Connect the power cords to the
various equipment.

POWER ON (6)
First switch on the projector, then
the source equipment to facilitate
correct recognition of the projector
as a peripheral unit to the
computer.

FOCUS AND POSITION
Position the projector for desired
image size (see Section 14.6), focus
the lens for an optically sharp image
and tilt the unit using the integral
adjustable feet to position the image
on screen.

RESET
Press RESET to automatically adjust
for position, width and stability.
RESET is automatically invoked
when a new source is connected.

CONTRAST AND BRIGHTNESS
Adjust CONTRAST and
BRIGHTNESS as preferred.