Zhone 5100 Reference Manual
Commands common to all interfaces
Vpacket 5100/6100 Series Reference Manual
59
Example 2:
In this example, the voice IP address is set to the WAN IP address.
Viewing IP addresses
You can view all IP addresses configured on a 5100/6100 VDR by issuing the show ip command.
Syntax: show ip
Example:
Syntax: show ip
Example:
In this example, all of the interfaces and corresponding information for the 5100/6100 VDR
deployment as shown in Figure 3-1 on page 54. The active Ethernet or LAN interface has an IP
address of 10.10.10.254 with a subnet mask of 255.255.255.0. The configured (CONFIG) WAN
interface is set to IP address 205.176.94.11 with a subnet mask of 255.255.255.0 and the voice IP
address is set to match the WAN interface IP address. When the voice IP address matches the
WAN address, the voice traffic is run through the WAN interface. The configured (ACTIVE)
default gateway is set to 10.10.10.254. The configured interfaces change to active state interfaces
after you issue the commit (ip) and save commands.
VPacket# set ip voice wan
VPacket#
VPacket# show ip
ACTIVE indicates this is the current operational setting
CONFIG indicates this has been configured but not activated
-------------------------IP INTERFACE----------------------
INTERFACE NAME IP ADDRESS NET MASK
ACTIVE lan 10.10.10.1 255.255.240.0 NATed
ACTIVE lan 13.13.13.254 255.255.255.0 NATed
ACTIVE lan 15.15.15.254 255.255.255.0 NATed
CONFIG wan 205.176.94.11 255.255.255.0
ACTIVE Default Gateway 10.10.10.254
ACTIVE Voice Ip Address 205.176.94.11
-----------------------------------------------------------
VPacket#