Eagle sport Operating Guide

8

Next, push the battery holder out the bottom of the battery cover as shown
below. Install each battery with the negative end (-) against the spring.
The positive end (+) of each battery should be firmly against the metal
plate. When all six batteries are installed, slide the battery holder into the
battery cover.

If the battery holder sticks when sliding into the battery cover, apply a thin
film of petroleum jelly to the “O” rings on the battery holder.

There are arrows molded into the bottom of the battery cover and battery
holder. Make certain the arrows are properly aligned! Otherwise, the bat-
tery holder won’t slide all the way into the cover and the battery pack
won’t slide onto the unit.

Slide the battery pack onto the unit and the AccuMap Sport is ready for
use.

EXTERNAL POWER
Instead of batteries, the AccuMap Sport can operate on 6 to 35 volts DC
from an external power source. To use external power, an adapter cable
must be purchased (model CA-1) that will plug into your vehicle’s ciga-
rette lighter. To use this cable, simply plug one end into the connector on
the side of the AccuMap Sport and the other end into the cigarette lighter.
A rubber plug is supplied with your AccuMap Sport to cover the external
power jack on the side of the unit when it’s not in use.