Affirmative 7370 User Guide

 

 

 
•  The battery shipped with your sample device may be low in power – please be prepared to use the 

AC-DC adapter with the YEStablet 7370 in setting up the device for the first time and to fully 
charge the internal battery pack.   

•  The YEStablet 7370 is delivered in a “Power Off” or “Reset State”.  To start (Cold Boot) the 

YEStablet 7370 for the first time, briefly push on the Reset button (

) located in a recessed 

opening at the back of the device.   

• 

BE CAREFUL

 when using the Reset button as part of normal device operation – you may lose all 

software settings and information you may have established through your pattern of usage.  See 

 for information on saving settings before using Reset. 

•  Please use (push and quick release) the Suspend button (

) to “shut off” the device while 

not in use.  In the Suspend mode, the wireless LAN adapter will disconnect from the access point.  
Pushing briefly on the Suspend button will wake up the system within seconds.  The Power scheme 
(see 

) can also be set to put the 7370 into the Suspend mode after a 

defined period of inactivity. 

 

 
The start-up sequence varies, depending upon whether you are executing a Cold Boot from the Reset 
mode or executing a Resume from the Suspend mode.   
 

 
1.  Using your stylus, briefly push on the Reset button (

) located in a recessed opening at the 

back of the device.   

2.  The Affirmative Computer Products logo screen appears within several seconds. 
3.  After approximately fifteen seconds, the Windows Desktop will appear, along with the YESterm IP 

Administrator window and a Calibration Request for your stylus. 

4.  If you want to calibrate your stylus pointing, click on Yes.  Then use the stylus to tap where 

indicated on the touchscreen in accordance with the displayed instructions. 

5.  If you don’t want to calibrate, click on No or Cancel.  Despite the information on the screen, 

clicking on No will sometimes not prevent a future request. 

6.  The wireless LAN adapter will have to establish a connection with a wireless access point.  If you 

are using a Cisco Aironet card, this will occur automatically after 10-15 seconds.  If you are using 

 

35