Affirmative 7370 User Guide

When your internal battery has discharged to approximately five percent of remaining life, the 
YEStablet 7370 will start generating warning messages at regular intervals (approximately five 
minutes). When the internal battery reaches the two-percent point, the 7370 will be placed into Suspend 
mode after a final warning.  If the YEStablet 7370 enters Suspend mode due to a Low Battery 
condition, the Suspend/Resume button cannot resume operation until an AC-DC adapter is connected 
directly or through the cradle. 
 
Within 12 hours, users can use an AC-DC adapter to return the machine to an operational state and to 
begin battery recharge.  If over 12 hours elapses without using the AC-DC adapter, the 7370 will 
automatically save Registry changes (see 

the only way to recover the system is by connecting an AC-DC adapter and then doing a 

. 

 

 
A cradle for support; pass-through charging, and communication with a PC complements the YEStablet 
7370.  On the cradle, you will find: a DC-in jack for the AC-DC adapter; a USB port for a USB cable; 
and a protected IR opening (not used at present).  Seat the YEStablet 7370 securely onto the cradle and 
use the procedure cited in this section to activate and verify the connection between the device and the 
cradle. 
1.  You may charge the battery pack(s) on the YEStablet 7370 by connecting the AC-DC adapter 

directly to the 

 on the YEStablet 7370 or through the DC-in Jack on the cradle while the 

YEStablet 7370 is docked on the cradle. 

 

 

 

          

 

 

 
2.  The slave-type (Type B) USB port on the cradle is used for connection between a desktop computer 

and the YEStablet 7370 when the device is docked on the Cradle.  This connection may be used for 
software installation, software update, and software development purposes.  The required 
ActiveSync software on the PC also leverages this connection for synchronization between PC and 
the YEStablet 7370. 
 
NOTE:  You will need to engage a pre-programmed button (

the USB Slave port (e.g., ActiveSync operation).  Removing the unit from this cradle or Suspending 
the unit is designed to cause the connection to be lost.  An “X” will re-appear across the Cradle 

 

38