Knoll hd102 User Manual

 

13

 
Remove the lens cap.  
 
Toggle the Power switch on the side of the 
projector to the On position. The LED 
flashes green and the fans start to run. 
When the lamp comes on, the start-up 
screen is displayed and the LED is steady 
green. It can take a minute for the image to  
achieve full brightness. 
 

? No start up screen? Get help on 
page 15. 

 
Plug in and turn on your video device. 
 
The video device’s image should appear 
on the projection screen. If it doesn’t, press the Video button on the keypad. 
 

? No image? Try pressing the Source or Auto Image Get help on 
page 15. 

 
 
 

Adjust the height of the projector by 
pressing the release button to extend the 
foot.

  

 
Rotate the leveling foot at the rear of the 
projector, if necessary. Position the 
projector the desired distance from the 
screen at a 90-degree angle to the 
screen. 
 
See page 27 for a table listing screen 
sizes and distances to the screen. 

 
 
 
 
 

Adjust the zoom and focus.  
 
 
 
 
 
 
 
 
If the image is not square, adjust the keystone using 
the buttons on the keypad. Press the top Keystone  
button to reduce the upper part of the image, and 
press the bottom Keystone button to reduce the 
lower part. 
 
 
 
Adjust the volume on the keypad or remote.