Aethra d2061 User Manual
USER’S MANUAL
ADSL TESTER D2061
In order to carry out the IP Ping test by using only one D2061, do
not insert any data into the field and press ENTER. The will set
automatically the item “Myself “ and will use its own IP address
as remote IP.
not insert any data into the field and press ENTER. The will set
automatically the item “Myself “ and will use its own IP address
as remote IP.
Ping request number: Insert the number of Ping (Echo) requests.
Max response time (sec): Maximum response time between Ping requests. The test
set waits this time before considering the request expired.
set waits this time before considering the request expired.
Data field length: Assign data field length of the Ping packet, to verify if the remote is
reachable a part from the packet length.
reachable a part from the packet length.
Don’t fragment: Verify if the remote is reachable whether with fragment or not
fragment packets.
fragment packets.
Trace route: Select “YES” in order to display, in the results, all the IP remote
addresses met before reaching the destination IP address. Are also provided
response times for each remote IP address so to verify bottlenecks detected over the
line.
addresses met before reaching the destination IP address. Are also provided
response times for each remote IP address so to verify bottlenecks detected over the
line.
Protocol type: Choose the network protocols stack according to the contract. Ask
the correct configuration to use to your local provider. The protocol types are the
following:
the correct configuration to use to your local provider. The protocol types are the
following:
• IP (ROUTER) / (BRIDGE) for IP protocols
• IP over PPPoA, for PPP protocols over ATM
• IP over PPPoE, for PPP protocols over Ethernet
• IP over PPPoA, for PPP protocols over ATM
• IP over PPPoE, for PPP protocols over Ethernet
IP over PPP is used on links where an initial authentication phase is needed
Authentication: Assign the authentication mode for IP over PPP protocols. Use
‘PAP and CHAP’ value to support both modes at same time.
‘PAP and CHAP’ value to support both modes at same time.
User Name: Insert the user name for identification. Only for IP over PPP
Password: Insert the user password. Only for IP over PPP.
IP address mode: Dynamic, used only in IP over PPP, sends an assignment request
of the local IP address. Static, the local IP address is configured manually.
of the local IP address. Static, the local IP address is configured manually.
Local IP: Insert the local IP address. Only in Static mode.
Subnet mask: Enter the Subnet Mask address to verify if the destination IP is placed
inside the local network. Only IP BRIDGE, Static.
inside the local network. Only IP BRIDGE, Static.
CHAPTER 3 - PERFORMING A MANUAL TEST
43