Anchor al-tx Product Datasheet

GETTING STARTED ................................................................................................................................................. 2
BELT PACK RECEIVER SETUP .................................................................................................................................. 3
BELT PACK TRANSMITTER SETUP .......................................................................................................................... 4
BASE STATION TRANSMITTER SETUP .................................................................................................................... 5
ASSISTIVE LISTENING SYSTEM OPERATION .......................................................................................................... 6
QUICK SETUP INSTRUCTIONS ................................................................................................................................ 6
ASSISTIVE LISTENING PACKAGES & ACCESSORIES ............................................................................................... 7
HAVING TROUBLE W/ YOUR SYSTEM? ................................................................................................................... 8
SYSTEM TECHNICAL SPECIFICATIONS .................................................................................................................... 8

No Sound 

•  power supply turned off on the transmitter and/or receiver

 

•  transmitter and receiver are set to different frequencies

 

•  transmitter output is not connected to mixer or amplifier input

 

•  receiver is too far from transmitter

 

•  metal object near transmitter or obstructions between transmitter & receiver

Sound Interference 

•  adjust the antenna location

 

•  when using 2 or more transmitters use different frequency setting for each

 

•  interference from other wireless microphone, TV, radio, etc.

Distortion 

•  transmitter volume level too high or to low

 

•  interference from other wireless microphone, TV, radio, etc.

Portable Sound Systems  •  Torrance, California

100-0158-000/A - 5/07

AL-TX – Base Station Transmitter
System Range 

Up to 200’ line of sight

Frequency Range 

UHF 682– 698MHz or 863 – 865MHz

RF Power Output 

682 – 998MHz @ 100 mW

 

863 – 865MHz @ 10 mW

Frequency Stability 

± 0.005%

Maximum Deviation 

± 48 KHz w/ limiting compressor

Spurious Emission 

> 60 dB below carrier frequency

T.H.D. 

< 1% @ 1KHz

Power Supply 

DC 12 ~ 18 V

Tone Key 

32.768 KHz

Current Consumption 

85 mA ± 10 mA (10 mW)

Dimensions 

(WHD) 

8.3 x 1.7 x 7.1” / 211 x 44 x 180 mm

WB-6000 – BELT PACK TRANSMITTER
RF Power Output 

10mW

Oscillator PLL 

synthesized

Maximum Deviation 

+/- 48 KHz

Spurious Emission 

> 60 dB below carrier frequency

Tone Key 

32.768 KHz

Power Supply 

DC 3V (2 x 1.5 V AA Batteries)

Current Consumption 

65 mA +/- 5 mA

Dimensions 

(WHD) 

3.86 x 2.60 x 1.02” / 98 x 66 x 26mm

(Specifications subject to change without notice.)

AL-WB – Belt Pack Receiver
System Range 

Up to 200’ line of sight

Frequency Range 

UHF 682– 698MHz or 863 – 865MHz

Oscillator PLL 

synthesized

Receiving Mode 

Single channel diversity

Frequency Stability 

± 0.005%

Receiving Sensitivity 

@ 5dBuV over 80 dB S/N ratio

Image & Spurious Rej. 

80 dB min

Selectivity 

> 50 dB

Modulation Mode 

FM

IF Frequency 

1st 56 MHz / 2nd 10.7 MHz

Dynamic Range 

> 96 dB

S/N Ratio 

> 94 dB @ 15KHz deviation & 

 

60 dBuV antenna input

AF Response:
     Headphone 

100 Hz – 10 KHz (± 3 dB)

     Line 

40 Hz – 15 KHz (± 3 dB)

T.H.D. 

< 1% @ 1KHz

Power Supply 

DC 3V

 (2 x 1.5 V AA batteries)

Audio Output:
     Headphone Stereo 

20 mW

     Line Stereo 

Level -10 dB

Current Consumption 

130 mA ± 10 mA

Dimensions 

(WHD) 

3 x 4.2 x 1.1” / 76 x 106 x 29 mm