Hitachi ut37v702 User Guide

24

ENGLISH

BASIC OPERATION (continued)

Input Switching to HDMI and RGB

By pressing the 

Input Select button 

, you can switch the 

input to display the image outputting from the external equipment 

connected to each terminal (HDMI and RGB (/Composite)).
<From Remote Control>

 Press the 

 button on the remote control.

Each  time  this  button  is  pressed,  the  screen  displays  the 

corresponding mode in the following sequence. 

HDMI

RGB (/Composite)

 Press the 

 or 

 button to directly select the input mode.

<From Control panel>

The Input modes can also be switched using the 

Input Select 

button on the control panel. 

Each  time  this  button  is  pressed,  the  screen  displays  the 

corresponding mode in the following sequence. 

HDMI

RGB (/Composite)

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the 

 button on the remote control.

 The display will go out in approximately 6 seconds.

HDMI

DVI

720p

Input mode

 *

Signal mode

*

 HDMI-DVI 

connection only

Composite

RGB

 H :   48.4kHz

V :   60.0  Hz

Input mode

Input horizontal 

frequency

Input vertical 

frequency

INFO 

button

Input Select

 Switching between RGB and Composite Mode

When pressing 

 button, you will see the image from either RGB or Composite mode. You can set up the 

mode in advance if necessary.
1.  Press MENU button in RGB or Composite mode.

2.  Select “Setup” menu.

3.  Select “RGB input”.

 Select 

“Composite” to display the image from a video source via the optional D-sub 15 pin - composite 

cable.

 Select 

“RGB” to display the image from PC.

See 

38

 and 

39

 for details of 

“RGB input” menu.

RGB Input 

Select button

HDMI Input 

Select button

Input Select 

button

Menu button