Alpine DVE-5207 User Guide
29
-EN
Installation
Check accessory parts.
RCA-extension
cable (for video
signal 2m)
cable (for video
signal 2m)
Remote control
2 Flat head screw
(M5
× 8)
5 Bolt stud
RCA-extension
cable (for audio
signal 2m)
cable (for audio
signal 2m)
Battery (CR2025)
3 Front frame
Remote control eye
(one set) (5.5m)
(one set) (5.5m)
1 Mounting sleeve
4 Hex nut (M5)
x 1
x 1
(Double-sided tape)
x 1
x 1
x 1
x 4
x 1
x 1
x 1
Installation Location
Before deciding on the mounting location, check that opening and
closing the display will not hamper the gear shift in any position.
closing the display will not hamper the gear shift in any position.
• Install at an angle of within 35 degrees from the horizontal.
Caution for installation
Be sure to remove the mounting sleeve squarely from the product,
refer to “Removal” (page 30).
refer to “Removal” (page 30).
1
Slide the mounting sleeve into the dashboard.
• Remove the wrapping from the unit.
2
Reinforce the unit with the metal mounting strap (not supplied).
Secure the ground lead of the unit to a clean metal spot using a
screw*
Secure the ground lead of the unit to a clean metal spot using a
screw*
1
already attached to the vehicle's chassis.
• For the screw marked*
2
, use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or equalizer
to the corresponding output lead coming from the left rear of
the DVE-5207. Connect all other leads of the DVE-5207
according to details described in the “Connections” section.
to the corresponding output lead coming from the left rear of
the DVE-5207. Connect all other leads of the DVE-5207
according to details described in the “Connections” section.
Continued
Mounting sleeve 1
(Included)
(Included)
Dashboard
DVE-5207
*
2
*
1
Metal
mounting
strap
mounting
strap
Chassis
Hex nut (M5) 4
Bolt stud 5
Ground lead
DVE-5207
Screw