Rimage 7100 Reference Guide
Producer Family™
Operator
2000246_B
© 2007, Rimage Corporation
1
Replace the Gripper Board Assembly on a Rimage Producer System
Use this procedure to replace the gripper board assembly in an Autostar II™, Protégé II™, Amigo II™, AutoPrinter II™,
Producer 7100™, Producer 8100™, Producer 7100N™, or Producer 8100N™.
Producer 7100™, Producer 8100™, Producer 7100N™, or Producer 8100N™.
Rimage approved parts must be used for this process. The product warranty may become void if parts not approved by Rimage are
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
used; equipment or parts are tampered with, misused, neglected, or modified in any respect without the written consent of Rimage.
Notes:
•
•
Your system may not look exactly like the system pictured.
•
The term “Producer” is used throughout this document to refer to the Autostar II, Protégé II, Amigo II, AutoPrinter II,
Producer 7100, Producer 8100, Producer 7100N, and Producer 8100N.
Producer 7100, Producer 8100, Producer 7100N, and Producer 8100N.
Before you begin
1. Stop or pause all jobs.
2. Power off the external or embedded control
2. Power off the external or embedded control
center.
3. Power off the Producer.
4. Disconnect
4. Disconnect
the
power cord from the power outlet.
#
Required tools:
•
Torx T10 screwdriver
•
Torx T15 screwdriver
Remove the Gripper Board Assembly
1. Access
the
lift arm.
•
If the system has a printer cover, remove the
printer cover.
printer cover.
•
If the system has a top access cover, open the
top access cover.
top access cover.
2. Open
the
front door.
3. Remove
the
carousel.
4. If there is a flex-cable clip on the lift
arm, remove the flex-cable clip by
pulling it upward.
pulling it upward.
Note: If there is no flex-cable clip,
continue with step 5.
continue with step 5.
Printer Cover
Top Access Cover
Lift Arm
(View from Rear)
Flex-Cable Clip