SATO CG412 User Guide
Section 3: Operation and Configuration
CG4 Series Operator Manual
Page 3-13
3.5
OPERATION SETTING MODE
(cont’d)
Notes:
• Press the FEED/LINE button to select the desired function, and then execute the selected function by
pressing and holding the FEED/LINE button for more than 3 seconds.
• When the desired interface is selected, this setting will be valid
after you restart the printer.
• When HEX dump mode is selected, the printer will be set to this mode only once by restarting the printer.
• When download mode is selected, the printer will be reset automatically and it enters the desired
• When download mode is selected, the printer will be reset automatically and it enters the desired
download mode.
• When the default setting mode is selected and executed, the printer will be set to default setting.
• Make sure that the function execution is complete (ON LINE (POWER) indicator: Green light) before
• Make sure that the function execution is complete (ON LINE (POWER) indicator: Green light) before
turning off the printer.
3.6 PROGRAM DOWNLOAD MODE
In this mode, the printer is set to receive an application program from the host computer to download into its
memory. Remember to set the printer to the correct active interface to be used for the data transfer.
memory. Remember to set the printer to the correct active interface to be used for the data transfer.
Status of printer in Program Download Mode
ON LINE (POWER)
indicator
ERROR
indicator
Buzzer
Activation via operation
setting mode or
download command.
setting mode or
download command.
Start-up
Reception
from interface?
from interface?
Yes
Reboot
command
reception?
command
reception?
Program data
reception?
reception?
Yes
Yes
No
No
No
Download
Download
completion
Reboot and start in normal mode
Test print
Online
At the start of download
mode
mode
Wait to receive data
Start receiving data/
Receiving data
Receiving data
Writing to flash ROM
At the time of download
completion
completion
Printer turns off
Printer turns on again
Test printing
(From step 4 of Operation Setting Mode. )
One long
beep
beep
One
short
beep
short
beep
One
short
beep
short
beep
One short
beep
beep
Red light (after
release of
FEED/LINE)
release of
FEED/LINE)
Off (after release of
FEED/LINE)
FEED/LINE)
Blinking red light
Off
Off (while pressing
FEED/LINE)
FEED/LINE)
Off (while pressing
FEED/LINE)
FEED/LINE)
Blinking green light
Off
Three
long
beeps
long
beeps
Blinking green light
Off
Blinking green light
(lights alternately)
(lights alternately)
Blinking red light
(lights alternately)
(lights alternately)
Green light
Off
Off
Off
Off
Red light
Green light
Off
Green light
Off