SATO CG412 User Guide

Section 8: Appendix

Page 8-4

If the paper is not taut, roll the paper on the media holder 
so that the paper is taut. 
Next, tightly close the pressure bracket with the liner 
(backing paper) passing through it.

Close the top cover until it clicks into position. 

After turning on the label, turn on the power. 
The printer is online and the ON LINE (POWER) indicator 
lights green.

When the printer is ready, press the FEED/LINE button to 
output an empty label and stop at the dispenser. This 
procedure is to ensure that the label is loaded correctly.

Normally, the label is dispensed to the point where 2 or 3mm (0.08” or 0.1”) of the label remain on the liner 
(backing paper).
If the label is not dispensed at the regular position, you can change the offset setting with the SBPL 
commands. After adjusting the stop position, dispense two or three labels to fix the stop position.

• There may be cases when the dispenser does not function properly due to the thickness of the labels 

used.

• The Dispenser unit is effective for label pitch 22 to 100 mm (0.86” to 3.93”). However, the label size limita-

tion may vary with application conditions.

• Labels over 100mm (3.9”) may curl at dispenser due to the nature of the material. There is no remedy for 

this.

Label output 
from here

Output 
backing 
paper