SATO MB410i User Guide
Unit 3: Setup
Page 3-6
PN 9001190C
MB400i/MB410i Operator Manual
CHARGING THE BATTERY PACK WITH A CHARGER
If your printer comes with the optional battery charger, you can use it to charge the supplied
battery pack. Follow the steps below:
battery pack. Follow the steps below:
Figure 3-5, Charging the Battery Pack with a Charger
1. Connect the power cord to the charger unit, then plug it to the wall outlet and turn on the
power.
2. Insert the battery pack into the slot, with the terminal pointing downward. When charging
begins, the CHARGE lamp (red) lights. When charging is completed, the CHARGE lamp
lights green (fully charged).
lights green (fully charged).
3. Remove the battery pack when charging is completed.
N
OTES
:
•
If the CHARGE lamp does not light at the start of charging, make sure the battery pack is
firmly mounted into the charger. Poor mounting of the battery pack may result in faulty charg-
ing.
firmly mounted into the charger. Poor mounting of the battery pack may result in faulty charg-
ing.
•
When the fully charged battery pack is placed into the battery charger, the CHARGE lamp
first lights red, then lights green.
first lights red, then lights green.
•
When charging a battery pack that has not been used for a long time, the CHARGE lamp
may blink for a while. This does not indicate an error. You can continue charging.
may blink for a while. This does not indicate an error. You can continue charging.
•
The battery pack can be recharged about 300 times (when used at normal temperatures). If
the battery pack is fully charged but runs out quickly, replace it with a new battery. The bat-
tery may still be used, but the battery life may degrade over time.
the battery pack is fully charged but runs out quickly, replace it with a new battery. The bat-
tery may still be used, but the battery life may degrade over time.
C
HARGING
T
IME
It takes about 1.5 hours for a fully discharged battery pack to return to a fully charged state.
CHARGE