SATO MB410i User Guide
Unit 4: Operation and Configuration
MB400i/MB410i Operator Manual
PN 9001190C
Page 4-27
To switch between Auto or Manual Print for the Dispense Mode, set the DIP switches as outlined
below, and then hold down the PRINT or FEED button when turning the printer ON. The new
settings take effect when the printer is next turned ON.
below, and then hold down the PRINT or FEED button when turning the printer ON. The new
settings take effect when the printer is next turned ON.
When setting the dispense mode, the STATUS LED blinks green, and turns into a steady green
signal upon completion of setting. Turn off the printer ONLY when the STATUS LED is a steady
green light.
signal upon completion of setting. Turn off the printer ONLY when the STATUS LED is a steady
green light.
OTHER PRINTER MODES
Available printer modes include Normal, Test Print, Head Check Setting and Online
Command Setting mode.
Command Setting mode.
In the Normal mode, a user can initiate printing or feed paper.
Test print mode allows the user to generate a print in order to check or correct any print quality
concerns, and to check the remaining battery life.
concerns, and to check the remaining battery life.
The Head check setting mode enables the user to set up the printer to determine whether the
printing area is correct, and to determine whether the printing area is limited to only barcode
printing.
printing area is correct, and to determine whether the printing area is limited to only barcode
printing.
In the Online command setting mode, the user can select the command or programming
language the printer should use.
language the printer should use.
Setting Auto Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open +
PRINT button + power ON
PRINT button + power ON
Setting Manual Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open +
FEED button + power ON
FEED button + power ON