SATO MB410i User Guide
Unit 5: Operating Modes
MB400i/MB410i Operator Manual
PN 9001190C
Page 5-3
N
OTES
:
A small label may produce a large amount of data when printing a Hex Dump.
When the onboard buzzer is enabled, it will sound when the printer is turned ON during DIP
switch setting. Release the FEED button to stop the buzzer.
switch setting. Release the FEED button to stop the buzzer.
To end any setting for Standard/Non-standard Control Code or Peeling Print or Online Command
compatibility, confirm that the STATUS LED is lit green. Then turn the printer OFF, and reset the
DIP switches as necessary.
compatibility, confirm that the STATUS LED is lit green. Then turn the printer OFF, and reset the
DIP switches as necessary.
WARNING
Never connect or disconnect interface cables (or use switch box) with power applied to either the
host or the printer. This may cause damage to the interface circuitry in the printer/host and is not
covered by warranty.
Never connect or disconnect interface cables (or use switch box) with power applied to either the
host or the printer. This may cause damage to the interface circuitry in the printer/host and is not
covered by warranty.
ON
OFF
OFF
OFF
CLOSE
OFF
OFF
Infrared
interface
interface
Normal startup mode
CLOSE
OFF
ON
-
Test printing mode
ON
OFF
ON
ON
CLOSE
OFF
OFF
Infrared
interface
interface
HEX dump mode
ON
OFF
OFF
ON
OPEN
ON
OFF
-
Head check (Barcode
printing area) setting
printing area) setting
OPEN
OFF
ON
-
Head check disabled
ON
ON
OFF
OFF
CLOSE
OFF
OFF
USB
interface
interface
Normal operation
CLOSE
OFF
ON
-
Test printing mode
ON
ON
ON
ON
CLOSE
OFF
OFF
USB
interface
interface
HEX dump mode
OPEN
ON
OFF
-
Set compatibility with
MB400 Online Com-
mands
MB400 Online Com-
mands
OPEN
OFF
ON
-
Set compatibility with
SBPL Online Com-
mands
SBPL Online Com-
mands
ON
ON
OFF
ON
OPEN
ON
OFF
-
Non-standard Control
codes
codes
OPEN
OFF
ON
-
Standard Control codes