Jobsite a30-x12 User Manual
6
Configuring Your System
Because the A30-X12 offers so many
configuration possibilities it is important to
plan carefully before you install it. Draw a
block diagram of your system and use the
Configuration Worksheet on page 7 to
record how you plan to connect your
A30-X12. Here is an example filled out
according to the block diagram on page 7.
Mark the cables with Wire labels,
describing where the cables originate from,
rather than where they will terminate.
configuration possibilities it is important to
plan carefully before you install it. Draw a
block diagram of your system and use the
Configuration Worksheet on page 7 to
record how you plan to connect your
A30-X12. Here is an example filled out
according to the block diagram on page 7.
Mark the cables with Wire labels,
describing where the cables originate from,
rather than where they will terminate.
Tools Required:
n
1/8" Slotted screwdriver
n
Wire stripper
n
Wire labels
INSTALLATION
Complete configuration
worksheet
worksheet
1. Select an appropriate location for the
A30-X12
2. Run all the necessary wiring to the A30-
X12. Label the wires for future reference.
3. Strip 1/4" of insulation from the end of
each speaker wire. Tightly twist the end
of each wire until no frayed ends remain.
of each wire until no frayed ends remain.
4. Unscrew the Red and Black speaker wire
connectors.
5. Insert each wire into the predetermined
Speaker Outputs, using the configuration
worksheet as the guide. Tighten the
connector until the wire is securely
clamped.
worksheet as the guide. Tighten the
connector until the wire is securely
clamped.
6. Connect the Pre-Amplifier or Receiver to
the predetermined Channel Inputs, using
the configuration worksheet as the guide.
the configuration worksheet as the guide.
7. Set the BusMatrix input switch setting for
each channel.
8. Set the position of the Turn On Mode
switch. Connect 12 Volt source if
applicable.
applicable.
9. Connect the AC power cord to the A30-
X12, and then plug it into an “Un-
switched” AC outlet.
switched” AC outlet.
10. Turn the Master Power switch on. The
switch is located on the front panel of
amplifier.
amplifier.
Control Output
This terminal provides a 12-Volt DC signal
suitable for triggering automated switchers,
motorized screens, some electric curtain
controls, etc. The trigger voltage is present
only when the amplifier is active or "on".
When the amplifier turns "off", the 12Volt
signal is off.
suitable for triggering automated switchers,
motorized screens, some electric curtain
controls, etc. The trigger voltage is present
only when the amplifier is active or "on".
When the amplifier turns "off", the 12Volt
signal is off.
Cascade Audio Outputs
The "Cascade Audio Outputs" enable you to
connect another amplifier to your
preamplifier output. The connectors are
gold-plated RCA phono jacks. Connect them
to another amplifier’s inputs with a standard
audio patch cable. The outputs are not
buffered; if you wish to daisy chain more
than 3 JobSite amplifiers you will need a
buffered distribution amplifier.
connect another amplifier to your
preamplifier output. The connectors are
gold-plated RCA phono jacks. Connect them
to another amplifier’s inputs with a standard
audio patch cable. The outputs are not
buffered; if you wish to daisy chain more
than 3 JobSite amplifiers you will need a
buffered distribution amplifier.
Level Adjustment Knobs
The rear panel level adjustment knobs allow
you to adjust the maximum output level of
any channel individually.
you to adjust the maximum output level of
any channel individually.