Revel sub15 User Guide

UNPACKING

UNPACKING THE SUB-15 (Continued)

4. If you plan to add spike feet, perform the instructions in the

last section, Installing Spike Feet Onto The Sub-15.

5. If you don’t use spikes, roll the subwoofer onto its bottom and

remove the top pad. Use caution to avoid scraping the finish or
pulling off the grille. 

UNPACKING THE LE-1

1. Set the packaged ULTIMA LE-1 on its top onto a rug or other

soft material.

2. Open the bottom flaps and fold them back. Roll the carton

over onto its exposed bottom pad.

3. Lift the carton off the ULTIMA LE-1 and set it aside, being

careful not to damage the contents.

4. Remove the top and front pads. Grab the sides and lift the

ULTIMA LE-1 up off its bottom pad.

INSPECTING THE SUB-15/LE-1

After unpacking both products, carefully inspect the ULTIMA
SUB-15 and LE-1 for possible damage due to shipping. If you 
discover any damage, immediately contact your Revel dealer for
further assistance.

Keep all packing materials for future shipping. In the unlikely
event a product will need repair, Revel will only accept a unit in its
original shipping carton. Using any other packing materials may
result in damage to the product and is not covered by the warranty.
See Obtaining Service on page 35 for additional details. 

INSTALLING SPIKE FEET ONTO THE SUB-15 

1. Verify the spike foot kit contains three (3) spike feet, three (3)

covers, one (1) trim ring, one (1) wrench, and an adhesive packet.

2. Using the enclosed wrench, remove the two front bolts and

trim rings from the bottom panel, as shown in Figure 3 (on
the next page). Hold onto the trim rings for step 3. Store the
bolts for possible future use.

IMPORTANT