Revel sub30 User Guide

INSPECTING THE REVEL ULTIMA SUB 30

After unpacking, carefully inspect the REVEL ULTIMA SUB 30 for
possible damage due to shipping. If you discover any damage,
immediately contact your Revel dealer for further assistance. Keep
all packing materials for future shipping. In the unlikely event a
product will need repair, Revel will only accept a unit in its origi-
nal shipping carton. Using any other packing materials may result
in damage to the product and is not covered by the warranty. See
Obtaining Service on page 28 for additional details. 

ADJUSTING THE SPIKE FEET 

ADJUSTMENT FOR UNEVEN HARD FLOORS 

1. Set the unit in its desired location. Turn the REVEL ULTIMA

SUB 30 onto its feet. Remove the end pad. 

2. Loosen the locking ring of the foot that is not in contact with

floor by rotating it counter-clockwise. 

3. Adjust the foot until it firmly touches the floor. Make sure

there is about a 1 ⁄ 4" clearance between the bottom edges of
the side panels and the floor. Tighten the locking ring by 
rotating it clockwise.

ADJUSTMENT FOR CARPETED FLOORS 

1. Remove the spike foot covers by turning them counter-clockwise,

and then store them for possible future use.

2. Loosen each locking ring by rotating it counter-clockwise.

Adjust each spike to extend past the thickness of the carpet
and add about a 1 ⁄ 4" for clearance.

3. Set the unit in its desired location. Turn the REVEL ULTIMA

SUB 30 onto its spikes. Remove the end pad. 

4. Verify that there is about a 1 ⁄ 4" clearance between the bottom

edges of the side panels and the carpeted floor. If not, turn the
unit back on its side and repeat steps 2 to 4  as necessary.

5. Tighten each locking ring by rotating it clockwise. Turn the

REVEL ULTIMA SUB 30 onto its spikes and try rocking the
unit to make sure all spikes contact the floor. 
If not, adjust the spikes as necessary.