Plus bf-030pc Software Guide
10
2.2.2 Setup
Setup the PC interface board according to the following procedure instructions.
* Switch off all power to the main unit (electronic blackboard) and the PC before starting
operations.
* Touch some nearby metal (for example a door knob or aluminum sash) to discharge any
static electricity built up on your body or clothes before starting operations.
(1) Loosen the screws securing the cover over the
expansion slot on the lower part of the unit, and
remove this cover.
remove this cover.
(2) Insert the PC interface board making sure it is
correctly aligned with the slot guide and secure it
in place with the screws just removed.
in place with the screws just removed.
(3) Plug the PC connection cable into the PC interface
board and plug the other end into the RS-232C
connector on the PC. One end of the cable has a
ferrite core to prevent noise (A). Connect this
end to the main unit side connector.
connector on the PC. One end of the cable has a
ferrite core to prevent noise (A). Connect this
end to the main unit side connector.
A noise suppressing ferrite core (A) is provided at
one end of the cable. Make sure that this end is
connected to the Copyboard connector.
one end of the cable. Make sure that this end is
connected to the Copyboard connector.
(4) Switch on the main unit power and complete preparations.
(5) Start up the personal computer.
* If the only serial port you can use as 25 pins instead of 9 pins, please purchase the
optional 9 pin/25 pin converter connector.
cover
M3 x 6 (2 screws)
(A)